OZO Power Track Installation Guide

All power tracks must be installed by certified electricians and to be installed on a flat surface. 

Turn off the mains power supply to your incoming electrical point before installation.

 

1. Mounting Backplate

(i) Identify the mounting position and draw the lines accordingly.

(ii) Align the top edge and position the backplate, mark the areas to be drilled.

(iii) Drill the holes.

(iv) Secure backplate with screws.

(For electrical point located within track’s terminal installation area)

(i) Open the terminal cover.

(ii) Connect wiring to terminal and cover the terminal cover.

(iii) Align power track over backplate and snap-fit into place to complete installation.

(For electrical point located outside of track’s terminal installation area)

(i) Complete step 2(i) and (ii) in Method A, then route the wires through the cable entry hole

(ii) Conceal the wires at the back of power track

(iii) Position your power track accordingly and snap-fit track over backplate to complete installation.